This is our external coil that we supply with all of our extrnal coil magnetos. This unit can be used in place of Vertex, Mallory, Don Zig and any other manufacturers external coils. Unit is solid state, so it can be mounted in any orientation. If you need a little extra juice, look a..

Price: $238.50

Never have to worry about your magneto losing its charge again and increase your amperage at the same time with our rare earth magnet assembly. These come complete and ready to run with a heavy duty neodymium magnet and steel CNC machined “claw” assembly. You can order the..

Price: $255.00

Replace your damaged or worn out condenser. This unit was installed as original equipment in our H-3 Magnetos and is also used on Mallory magnetos that have been upgraded to produce higher than stock amperage. The rating on this condenser is 1μF.

Price: $44.52

These come in a set of six shims that include two .005, .010 and .020 inch shims. This will allow you to shim your base to the correct .005 tolerance that will maximize gear and bushing life.

Price: $4.95

Replace your worn or missing cam wiper to ensure that you get the maximum life out of your points. The wiper lubes the breaker cam over time so that the phenolic rubbing block on the points doesn’t wear prematurely.

Price: $10.44

Replace your damaged or missing Cross Shaft in your tach drive base with this new unit. This shaft along with a nylon insert (sold separately) will allow the use of a mechanical tachometer with your magneto.

Price: $69.50

Replace your worn or missing Tach Drive Nut with this new unit. Often times these are missing or have the outer threads cross-threaded beyond repair. This part is a new factory replacement that has bronze bushings installed and is ready to run.

Price: $58.30

Replace your missing or damaged Tach Drive Lock Plates with these new factory replacements. This Lock Plate is used to keep the Tach Drive Nut from coming loose.

Price: $22.15

Replace your worn of missing Point Plate Bearing with this new factory unit. An old bearing will allow the breaker cam to move side to side, which will not allow the points to be gapped accurately on all cylinders. Unit is a pre-lubed, sealed cartridge bearing that is pressed into the point pla..

Price: $42.00

Replace your worn or missing Point Plate with this new factory unit. Over time the stud that the points pivot on can become loose which will not allow the points to be gapped accurately on all cylinders. Features a nickel coated Point Plate with a pre-lubed, sealed cartridge bearing alread..

Price: $74.14